Foundation Repair and Augmentation Systems for Residential, Commercial and Industrial Applications.

For stabilizing/lifting foundations or retrofitting to increase load capacity, CHANCE® steel piers are installed at intervals around the perimeter at affected locations. Independent of the structure, the piers are extended to depths which attain the installing torque correlated to the required load bearing capacity.

• About Chance
• New Foundation
• Foundation Repair
• Soil Screw
• Tie Back
• Photos
• Watch Video

Special brackets are located where needed around the perimeter and secured to the concrete foundation. Then a steel pier is torqued into the soil through each bracket.

The brackets permit lifting by hydraulic jacks. Tightening the nuts on the bracket vertical bolts locks off the load.

Cutaway close up of drive end bearing on shallow rock stratum

Reach competent soil below active zone Predictable via torque-to-capacity ratio No excavation or spoils to remove Loads may be immediately applied Installs in limited access/low headroom Installs in any weather condition